50950260/AP1216 63
and supports. Serious personal injury could result from improperly
raising or blocking the skid-steer loader.
1. Using a jack or hoist capable of lifting the fully-equipped weight of the loader
(with all attached options), lift the rear of the loader until the rear tires are off
the ground.
2. Stack wooden blocks under the flat part of the loader chassis. They should run
parallel with, but not touch, the rear tires (Figure 4).
3. Slowly lower the loader until its weight rests on the blocks. If the tires still
touch the ground, raise the loader again, add more blocks and lower again.
4. Repeat Steps 1 through 3 for the front end. When the procedure is finished, all
four tires will be off the ground so they can be removed.
Loader Lowering Procedure
When service or adjustment procedures are complete, the skid-steer loader can be
taken down from the “raised” position. To lower the loader onto its tires:
1. Using a jack or hoist, raise the front of the loader until its weight no longer
rests on the front blocks.
2. Carefully remove the blocking under
the front of the loader.
3. Slowly lower the loader until the front
tires are resting on the ground.
4. Repeat Steps 1 through 3 for the rear
of the loader. When the procedure is
finished, all four tires will be on the
ground and the blocks removed from
under the loader.
Replacement Parts
Note: Part numbers may change. Your Gehl dealer will always have the latest
part numbers.
Part Description Gehl Part No.
Air Cleaner Element, Primary 188814
Air Cleaner Element, Secondary 188817
Hydraulic Oil Filter Element 074830
Engine Oil Filter Element 195568
Fuel Filter Element - DPF Models 50352551
Fuel Separator Element - DPF Models 50352550
Fuel Filter Element - Non-DPF Models 137500
Fuel Separator Element - Non-DPF Models 182130
To Next Page
Loading...