Gehl R105 X-Series - Page 71

50950260/AP1216 67
Lubrication Procedure
10 Hours
(or Daily)
50
Hours
250
Hours
500 Hours
(or Yearly)
Check Engine Oil Level (page 70)

Check Hydraulic Oil Level (page 78)

Grease Hitch, Hitch-related Cylinder Pivots
and Latch Pins (page 65)

Grease Lift Arm Pins (page 65)

Check Oil Level in Chaincases (page 80)

Change Engine Oil and Filter (page 71)

Change Hydraulic Oil Filter (page 78)

Change Hydraulic Oil (page 78)

Change Chaincase Oil (page 80)

Check and Drain Water Separator (page 71)

Replace Filter in Water Separator (page 71)

50/250
250
10
50/500
500
250
Figure 6 Service Locations (see Maintenance Chart on page 97.)
 Perform the initial procedure at 50 hours, then at the indicated intervals.