Genesis KBE2 User Manual

KBE2-2101-P
P/N 11040
230VAC Input • 1HP (0.75 kW)
INSTALLATION AND OPERATION MANUAL
KBE2 DIGITAL AC
ADJUSTABLE SPEED DRIVES
for use with 1/4 - 3 HP 3-Phase Induction Motors
115, 208/230 or 380 - 460 Volts, 50/60 Hz, 1 & 3 Phase AC Line Input
This Manual Covers
Panel Mount IP-20: KBE2-1125-P, 1150-P, 1101-P, 2125-P, 2150-P
2101-P, 2202-P, 2203-P, 4301-P, 4302-P, 4303-P
NEMA-4 / IP-65: KBE2-1125-4, 1150-4, 1101-4, 2101-4
2202-4, 2203-4, 4301-4, 4302-4, 4303-4
POWER CONV.EQ
LISTED 16KJ.
E177007
ISO
9002
Automation and Control
© 2003 KB Electronics, Inc.
(See back cover)
The information contained in this manual is intended to be accurate. However, the
manufacturer retains the right to make changes in design which may not be included herein.
!
See Safety Warning on page 6
Note: This drive has
been programmed
to operate 60 Hz
motors. For 50 Hz
motor operation,
see Section VIII-C
and Table 11 on
page 30.

Genesis KBE2 Specifications

General

Brand	Genesis
Model	KBE2
Category	DC Drives
Language	English

Summary

Simplified Instructions

AC Line, Ground, and Motor Connections

Power Up and Basic Keypad Operation

Initial steps for powering the drive and basic keypad controls.

Safety Warning

General Safety Warnings

General safety warnings and hazard symbols for safe operation.

Mounting Instructions

Mechanical Specifications

Mounting Guidelines

Recommendations for vertical mounting and ventilation for optimal drive performance.

Terminal Blocks TM1 and TM3 Wiring Instructions

TM1 and TM3 Terminal Block Layouts

AC Line Connection

Instructions for connecting the AC power source to the drive terminals.

Ground Connection

Procedure for establishing a proper earth ground connection for the drive chassis.

Terminal Block TM2 Wiring Instructions

TM2 Terminal Block Layouts

External Start/Stop-Forward/Reverse Connection

Wiring for external start/stop and direction control.

External Frequency Control

Methods for controlling motor speed using external signals.

Signal Input Type Selection

Remote Speed Potentiometer Connection

Voltage Following Connection

Current Following Connection

Multifunction Input Terminals 6 and 7 Connection

Drive Operation

Digital Keypad Description

Explanation of the drive's digital keypad layout and functions.

Digital Keypad Operation

Step-by-step guide for operating the drive using the keypad.

Setting Drive Output Frequency

Key Function Configurations

Configuration of essential drive functions and operational modes via keypad.

Programmable Functions Summary

Programmable Functions (Detailed)

F01 Acceleration Time

Sets the time for the drive to accelerate to the target frequency.

F02 Deceleration Time

Sets the time for the drive to decelerate to a stop.

F03 – External Forward-Stop-Reverse Control

Configures external control for motor direction and start/stop.

F04 – Motor Direction

F05 – Volts/Hz Pattern

F06 – Output Frequency Upper Limit

F14 – Stop Method

Selects between controlled deceleration or coast-to-stop.

F18 – Electronic Motor Overload Protection

Configures motor overload protection based on current.

F23 - Auto Restart After Fault

F25 – Reset Drive to Factory Settings