21
Resource Pro
WATER CONTACT ACTIVATION (BACKUP METHOD)
NOTE: Water contact will only activate the unit if the Wet Activation
feature is Set ON (a user setting).
The Resource Pro has 2 contacts that cause it to activate and enter Surface, or Dive, Mode when
the space between the contacts is bridged by a conductive material (e.g., water contact).
If the Wet Activation feature is Set On and the water contacts are bridged when the unit shuts
Off, it will automatically reactivate.
WARNING: Never attempt to activate the Resource Pro underwater. This
may result in inaccurate depth and no-decompression time displays. If the
unit is activated when deeper than 4 feet (1 meter) underwater, or at
elevations higher than 14,000 feet (4,267 meters), it will perform a
diagnostic check followed by immediate shutdown.
Upon activation and every 30 minutes while on the surface, the Resource Pro will also check the
ambient barometric pressure, and calibrate its present depth as zero. At elevations of 2,000 feet
(610 m) or higher, it will recalibrate itself to provide adjusted No Decompression limits.
WARNING: If any display or function varies from the information
presented here, return the Resource Pro to your Authorized Genesis
Scuba Dealer for inspection.
N
R
E
S
P
O
N
S
I
B
L
E
D
I
V
E
R
To Next Page
Loading...
Need help?
General
