50
CARE AND CLEANING
The Resource Pro is a sensitive electronic instrument. Although it has been built to endure the rigors of diving, it still must
be handled carefully to protect it from shock, excessive heat, chemical attack, and tampering. The housing is made of an im-
pact resistant resin that is shock resistant but susceptible to scratches and attack by strong chemicals.
CAUTION: Never spray aerosols of any kind on, or near, the Resource Pro. The propellants may
chemically attack the plastic.
Be careful not to leave it in an unsupervised, unprotected location where it might be damaged. Many dive computers (and
dive trips) are ruined due to carelessly tossed weight belts or cylinders.
If the lens becomes scratched, Genesis Scuba can replace it, although small scratches will naturally disappear underwater.
For even more convenience and additional protection against scratches, place a transparent Instrument Lens Protector on the
gauge face. This can be purchased from your Authorized Genesis Scuba Dealer.
CLEANING
Soak and rinse the Resource Pro in fresh water following each day of diving, preferably after each dive, and ensure that it is
free of any debris or obstructions that would block the sensors. If possible, use lukewarm water to dissolve any salt crystals.
Salt deposits can also be dissolved using a 50% vinegar/50% fresh water bath. Towel dry before storing, and transport your
Resource Pro cool, dry, and protected.
CAUTION: Never, under any circumstances, poke any object through any slots or holes on the rear
side of the Resource Pro. Doing so may damage the Depth Sensor, possibly resulting in
erroneous depth and/or dive time remaining displays.
To Next Page
Loading...
Need help?
General
