58
RETURNING THE MODULE TO BOOT
If the Boot was fitted with a Spacer and it was previously removed, replace the Spacer into
the Boot.
Orient the Module over the opening in the Boot, and dip the bottom edge into it while
pressing the top edge with the palm of your hand. Stop pressing when the bottom edge of
the Module has just entered the Boot.
Correct the alignment of the Module as needed so that it is straight.
Press the Module completely into place with your thumbs, watching the alignment, until it
snaps into place.
R
E
S
P
O
N
S
I
B
L
E
D
I
V
E
R
NOTE: The Wet Activation Contacts are located on the stem of the
Button and on metal Pins located on the lower left side of the
module. The Resource Pro module is designed for use in a Boot
that has an opening on the left side which exposes the Pins (and
side Wet Activation Contact) to water upon immersion.
WARNING: If the Resource Pro is installed in a Boot that does not
have the side opening where the side Wet Activation Contact is
located, the unit may not activate automatically upon descending
on a dive.
N
To Next Page
Loading...
Need help?
General
