57
Resource Pro
The tabs on the Retaining Ring fit down into the two slots located at the 2 and 8 o'clock
positions.
Using your fingers, turn the Ring counter clockwise 5 degrees until the tabs engage (Fig.
50), then tighten it 5 more degrees by turning it counter clockwise with the aide of a small
blade screwdriver (Fig. 51).
NOTE: While tightening (turning) the Retaining Ring, exert continuous
inward pressure on it until it is secured in the proper position. A small
symbol located on the Ring should be aligned with the Locked symbol
located on the Housing (Fig. 51 a/b)
Inspection
Activate the unit and watch carefully as it performs a full diagnostic and battery check,
and enters Surface Mode. Observe the LCD display to ensure it is consistently clear and
sharp in contrast throughout the screen.
WARNING: If there are any portions of the display missing or appearing
dim, or if a Low Battery condition is indicated, return your Resource Pro to
an Authorized Genesis Scuba Dealer for a complete evaluation before
attempting to use it.
Fig. 50 - Retaining Ring Tabs
Fig. 51 - Securing the
Retaining Ring
N
a
b
To Next Page
Loading...
Need help?
General
