23
Resource Pro
FT
ENTERING SETTINGS
The Set Mode allows you to set, or verify, Units of Measure (Imperial or Metric), 12/24 Hour
Format, Time of Day, and Wet Contact Activation On/Off.
Time must be reset when the Battery is removed for more than 8 seconds.
NOTE: While in Set Mode, the unit will revert to the Surface Sequence if
there is no button action for 2 minutes.
TO ACCESS SET MODE AND ENTER SETTINGS
While the unit is scrolling through the Surface Sequence -
Press and hold the button down for 2 seconds, releasing it when the Set Units screen ap-
pears. F (or C) and FT (or M) will be displayed flashing (Fig. 12).
Momentarily press and release the button (< 2 seconds) to toggle between Imperial and
Metric Units of Measure.
Press and hold the button down for 4 seconds to save the selection, releasing it when the
Set Hour Format screen appears. During the 4 seconds a screen displaying the graphic
EA will appear momentarily and be bypassed.
Although within the Set Mode Sequence, the EA feature is not a setting and has no user
function. It is used only by the factory to facilitate calibration.
Hr and 12 (or 24) will be displayed with 12 (or 24) flashing (Fig. 13).
Momentarily press and release the button (< 2 seconds) to toggle between 12 and 24.
Fig. 13 - Set Hour Format
Fig. 12 - Set Units of Measure
N
To Next Page
Loading...
Need help?
General
