53
Resource Pro
NOTE: Genesis Scuba strongly advises that you replace the Battery and
DO NOT attempt to dive when the Battery symbol remains on the display,
and that you replace the Battery with a new one prior to any multi day dive
trip.
BATTERY REPLACEMENT PROCEDURES
MODULE REMOVAL FROM BOOT
If the Resource Pro is in a Wrist Boot, it will be necessary to peel the lips of the Boot downward
off the Module while applying pressure from underneath, working it out slowly.
If it is in a Console, bend the rubber Console Boot back to expose the edge of the Module. If the
Boot is flexible enough to permit, you may bend it back far enough to scoop the Module out with
your finger. Otherwise, it may be necessary to insert a blunt screwdriver until the tip rests just
underneath the Module. DO NOT pry the Module from the Console! Slowly increase the pres-
sure under the Module by releasing the tension on the rubber Boot. The Module will slide up the
screwdriver and exit the Console.
CAUTION: The procedure that follows must be closely adhered to.
Damage due to improper battery replacement is not covered by the
Resource Pro's limited 2 year warranty.
N
Responsible
To Next Page
Loading...
Need help?
General
