WP21 Series Operation Manual Chapter 5 Routine Operation
24
5.3.2 Aspirating distilled water
After aspirating the cleaning solution, the system will automatically
enter the “Aspirate Distilled Water” interface, as illustrated in Figure
5-8:
Figure 5-8
Operators can perform the following operations:
Place distilled water onto the analyzer and press the number key “1” to
confirm. Then, the instrument will begin to aspirate distilled water and
measure its ADC value, the screen is displayed as Figure 5-9:
Figure 5-9
Every time after the filter wheel rotates, the system will prompt you to
To Next Page
Loading...