Geodimeter 600 - Page 101

1.3.25
STATION ESTABLISHMENT CHAPTER 3
GEODIMETER SYSTEM 600
PRG
20
From previous page.
10:18
ELE= x.xxx
Replace Z?
YES
This is your old station ground
elevation.
Press YES (ENT) if you want to
replace the old elevation with the new
or press NO to cancel it. In this
example we press YES.
(This display will only appear if the
ground elevation has already been
determined).
Enter your instrument height (IH).
For example, 1.75.
Key in the Pno of your reference
object. For example, 1102.
Key in the name of the Area file in
which you have stored your reference
object. If you leave the line blank you
will have the opportunity to enter the
coordinates manually in the same
way as for the station coordinates.
Are your coordinates correct? Press
YES to accept them. If you press No
you return to the question Refobj=. If
they have to be changed, use Edit or
P43 (Enter Coordinates). We will
continue by accepting them.
Note ! ☛
Only
shown if
your
coordinates
includes
ELE.
Note ! ☛
Only
shown if
your
coordinates
includes
ELE.
YES
10:18
IH =
1.75 ENT
Pno =
1102 ENT
Ref ok ?
N=xxxx
E=xxxx
ELE =xx
ENT
Area =
1
Known stn+