2.7.13
DATA LOGGING CHAPTER 7 GEODIMETER SYSTEM 600
0
3
4
5
20
21
22
23
30
35
Description
Instrument operating correctly, all required data are
available.
The measured distance has already been recorded.
A new distance measurement is required.
Measurement is invalid and recording not possible.
Recording is not possible with the selected mode
setting of the Geodimeter instrument.
Label error. This label cannot be handled by the
instrument.
Parity error in transferred data (between Geodimeter
and interface).
Bad or no connection, or wrong device connected.
Time Out
Syntax error.
Data error.
Output format.
The standard format of data from the interface is:
< Label > = < data > CRLF
Status
Status is a numeric value, transmitted before measurement
data, and indicates those values which are about to be trans-
mitted. This status value is non-zero if an error is detected.
See table 7:4 for status description.
End of Transmission
The end of transmission, EOT, character is set in label 79,
where the equivalent ASCII number is set. (Default is 62, e.g
">"). If set to 0 no EOT will be sent.
Value
Tab 7:4 Status Description
To Next Page
Loading...