1.3.18
STATION ESTABLISHMENT CHAPTER 3
GEODIMETER SYSTEM 600
PRG
20
ENT
ENT
From previous page
Known Stn.
In which memory unit is the Area file
stored? In this example we are using
the internal memory (Imem).
Enter the coordinates manually
Enter your station coordinates. Leave
the ELE blank for no height
establishment. (This display will only
appear if you have left the Area file
line blank.
Are your coordinates correct? Press
Yes (ENT) to accept them. If you
press NO you will return to the
question about STN= and Area=. If
the coordinates have to be changed,
use Edit or P43 (Enter Coordinates).
In this example we will continue by
accepting them.
Are you going to measure heights?
Accept this question by pressing ENT
(Yes). If you decide not to measure
heights (press No) it means that the
instrument height (IH) and signal
height (SH) will be ignored.
In this example, we will be measuring
heights. Press ENT.
See next page
Coord 10:17
N=xxxx
E=xxxx
ELE=xx
Stn ok? 10:17
N=xxxx
E=xxxx
ELE=xx
Note !
☛
Enter the
coordi-
nates
manually.
10:17
HT measure?
Note !
☛
Only
shown if
your
coordi-
nates
includes
ELE.
Sel device10:17
1 Xmem
2 Imem
2
1
ENT ENT
To Next Page
Loading...