[Storage Settings]
îš„ Enable recycling: If Enable recycling is selected, when the space of
the storage device is lower than the specified space, the system will
overwrite the oldest recorded files. If
Enable recycling is not selected,
the system will stop recording when the specified space is reached.
îš„ Keep days (1-255): Specify the number of days to keep the files from
1 day to 255 days. When both Keep days and Enable recycling are
selected, the system applies whichever condition comes first. For
example, if the specified smallest amount of storage space comes
earlier than the designated keep days, then recycle is applied first.
îš„ Enable debug message to the storage: Note this function is not
supported for
Target Series. Debug message (see 21.8.4 Log
Information) is deleted after reboot. Select this option to store log
information to an inserted storage device.
îš„ Enable auto formatting when disk or partition is enable to record:
Note this function is not supported for
Target Series. Select this
option for the camera to automatically format the storage device when
there is error during recording.
[Disk Information]
Note this function is not supported for Target Series. This section shows
the details of the attached storage device. Use the
Format/Remove button
to format or unload a storage device. For detail steps, see Partition
Information below.
368
To Next Page
Loading...
Need help?
General
