Chapter 22 Recording and Playback
Note that Recording and Playback function is not available for Target
Series
.
The GV-IPCAM H.264 can record video and audio directly to the memory
card. You can play back the recorded files on the GV-System or over the
TCP/IP network.
Note: See Note for Recording at the beginning of the manual.
22.1 Recording
To enable the recording function:
1. Insert the memory card to the camera. See “To add a memory card”,
21.8.2 Storage Settings.
2. If you like to set up the pre-recording, post-recording or audio
recording, see 21.1.1 Video Settings.
3. If you like to set up the schedule for video recording or I/O monitoring,
see 21.5 Recording Schedule.
4. If you like to configure the areas and sensitivity values for motion
detection, see 21.1.2 Motion Detection.
5. If you want the recording to be triggered by input device, configure the
operation of input device. See 21.2.1 Input Settings.
6. To start recording and I/O monitoring, see 21.4 Monitoring.
The camera will start recording in case of motion detection, I/O trigger, or
during the scheduled time.
To Next Page
Loading...
Need help?
General
