5-6
Using BIOS Setup and System Recovery
Wake Up Capability specifies events for waking up the system from S3
(Sleep) state. Press Enter to access the submenu as shown below.
Information Main Advanced Security Boot Exit
Wake Up Capability: Item Specific Help
Any-key Wake Up From S3:
Ring Wake-Up From S3
USB Wake-Up From S3
[Disabled]
[Disabled]
[Disabled]
Allow any key to wake
up the system from S3
(Sleep) state.
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select X Sub-Menu F10 Save and Exit
Any-key Wake Up From S3 allows any key to wake up the system from
S3 (Sleep) state.
Ring Wake-Up From S3 allows a modem activity to wake up the system
from S3 (Sleep) state.
USB Wake-Up From S3 allow a USB device activity to wake up the
system from S3 (Sleep) state.
System Policy sets the system performance. When set to
Performance
, the
CPU always runs at full speed. When set to
Balance
, the CPU speed changes
according to the current workload, therefore balancing between
performance and power consumption.
AC Initiation sets if connecting AC power will automatically start or resume
the system.
SATA Mode set to
AHCI
if your hard disk supports AHCI. AHCI allows you to
take advantage of Advanced Host Controller Interface features. The options
are
IDE
and
AHCI
.
CAUTION: Incorrect SATA mode settings can result in hard disk drive boot
failure.
Disabled