Repair and adjustment
6
Service instructions
5015108-00 Edition 0403
Loading a program to flash memory
The flash memory can be loaded with new wash programs or new system programs. Loading
new wash programs requires the CS-1000 program, which can be purchased from Getinge.
Instructions are supplied with CS-1000. System programs and language versions are loaded
with Flashloader.
Loading system programs
Note:
Always make a backup copy before starting work on updating system programs.
1. Connect a PC to the machine; see under Connecting a PC.
2. Check that the machine is in STANDBY mode.
3. Make a backup copy by starting CS 1000 and choosing Tools/PACS RAM/Upload To File...
4. Save the *.prm file in your chosen location.
The program will report an error during conversion. Disregard this. To check that conversion
was successful, check the size of the *.prm file. The size of the file should be 84416 bytes.
5. Switch off the power to the machine with the main switch.
6. Change the jumper (X29) on the board for the PACS 300 control system from Normal to Test.
Flash
Prom
X28
X29
TEST
Norma
X30
ON OFF
V1544
V1577
To Next Page
Loading...
Need help?
General
