62
SSID (3): This is the name of wireless router. You can type any
alphanumerical characters here, maximum 32
characters. SSID is used to identify your own
wireless router from others when there are other
wireless routers in the same area. Default SSID is
‘default’, it’s recommended to change default SSID
value to the one which is meaningful to you, like
myhome, office_room1, etc.
Channel Number (4): Please select a channel from the dropdown list of
‘Channel Number’, available channel numbers are
1 to 13 for European countries, 1 to 11 for USA. You
can choose any channel number you want to use,
and almost all wireless clients can locate the
channel you’re using automatically without any
problem. However, it’s still useful to remember the
channel number you use, some wireless client
supports manual channel number select, and this
would help in certain scenario when there is some
radio communication problem.
Associated Clients (5): Click ‘Show List button, then an “Active Wireless
Client Table” will pop up. You can see the status of
all active wireless stations that are connecting to the
access point.
NOTE: If you don’t have special reason to limit the type of allowed
wireless client, it’s recommended to choose ‘2.4 GHz (B+G+N) to
maximize wireless client compatibility.
NOTE: For 802.11b and 802.11g mode, the signals can be transmitted
only by antenna 1 (The antenna in the right side of the rear panel).
For 802.11n mode: The router is operating in a 1T2R Spatial
Multiplexing MIMO configuration. 1 antenna is for signal transmitting
and 2 antennas are for signal receiving.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
