64
2-7-1-3 Setup procedure for ‘AP Bridge-Point to Point’:
In this mode, you can connect your wireless router with another, to
combine two access points and expand the scope of wireless network, and
all clients (wired only – AP will not accept wireless clients in this mode)
of two wireless routers will think they’re on the same physical network.
This function is very convenient when you need to connect two networks
between two buildings. Here are instructions about how to connect two
wireless routers together:
Here are descriptions of every setup items:
Band (2): Select the band you want to use, two wireless
routers must use the same setting.
Channel Select the channel you want to use, two wireless
Number (3): routers must use the same setting.
MAC
address 1(4): Input the MAC address of another wireless router.
Set Click to setting security for this connection
Security (5): (Please go to section ‘2-7-3 Wireless Security’
for detailed instructions).
NOTE: Two wireless routers must use the same mode, band, channel
number, and security setting!
1
2
3
4
5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
