68
wireless router from others when there are other
wireless routers in the same area. Default SSID is
‘default’, it’s recommended to change default ESSID
value to the one which is meaningful to you, like
myhome, office_room1, etc.
Channel Select the channel you want to use, all the wireless
Number (4): clients must use the same setting.
Associated Clients (5): Click ‘Show List button, then an “Active Wireless
Client Table” will pop up. You can see the status of
all active wireless stations that are connecting to the
access point.
Root AP SSID (6): In ‘Universal Repeater’ mode, this device can act as
a station to connect to a Root AP. You should assign
the SSID of the Root AP here or click ‘Select Site
Survey’ button to choose a Root AP.
Site Survey (7): Click ‘Select Site Survey’ button, then a “Wireless
Site Survey Table” will pop up. It will list all
available access points near by. You can select one
access point in the table and the router will join
wireless LAN through this access point.
After you finish the wireless setting, please click ‘Apply’ button, after
you click ‘Apply’, the following message will be displayed on your web
browser:
Please click ‘Continue’ to back to previous setup menu; to continue on
router setup, or click ‘Apply’ to reboot the router so the settings will take
To Next Page
Loading...
