MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017 Page C-5
Configuring Site Server IP Addresses for Applause
Media System (when IP Addresses Are Changed)
4 Click Network Settings. The Network Settings screen appears. Make the required changes
under Ethernet Settings.
Figure C-5: Site Server
Note: The settings shown in this figure are the Gilbarco default IP address settings. The default
value for Dispenser Download Bandwidth Limitation is 1 MB/s. Usually, this value does not
need to be modified.
5 Select Continue at the bottom of the screen.
6 Click Apply New Settings on the next screen after you have reviewed the settings, and follow
the instructions to reboot the server.
Note: You will be prompted to reboot the server two times. Recor
d your settings for later use.
If the entire IP address scheme at the site needs to be c
hanged, then the dispenser IP addresses
will also need to be reprogrammed to match the site server. This can be done through CRIND
diagnostics or a laptop connected to the LRE or a router.
Note: If there are any problems during this pr
ocess, consult ASC.
To Next Page
Loading...
Need help?
General