Page C-6 MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
Configuring Site Server IP Addresses for Applause
Media System (when IP Addresses Are Changed)
Configuring Network for Gilbarco Dispenser IP Addresses
Configuring Network for Gilbarco Dispenser IP Addresses
Perform a “Print System Health Report” command at the dispenser to retrieve the existing
site’s IP addresses. You must have a service diagnostic card to be able to print a system
health report. This can be done by pressing CLEAR on the customer keypad and then
inserting a diagnostic card into the card reader within 30 seconds.
IMPORTANT INFORMATION
CRIND side IP addresses must not be changed from factory default unless one of the
following two conditions apply:
• The site requires a non-standard IP scheme. This includes any IP scheme that is not in
the 10.5.48.XXX range.
• The site is configured for non-standard CRIND IDs. For example, dispenser 1 is
configured for CRIND IDs 1/4 instead of 1/2.
WARNING
To configure the network IP addresses at the dispenser, proceed as follows:
From the main menu, press 3 > Enter. The Network Config screen appears.
Note: Enter key must be pressed after each keystroke.
Figure C-6: Network Config Menu
Network Config
1. Reset to Default IPs
2. Set IP Addresses
3. Apply Network Settings
4. View Network Settings
5. Hide Network Settings
6. Network Settings (Hidden)
Cancel = Exit
To Next Page
Loading...
Need help?
General