EasyManuals Logo

GILBARCO VEEDER-ROOT Applause Media System User Manual

Default Icon
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017 Page D-1
Configuring Cisco® Router Broadband Router and Network Configuration
Appendix D – Broadband Router and Network
Configuration
Configuring Cisco
®
Router
To configure the Cisco Router (Q13708-08B), proceed as follows:
1 Ensure the router is powered up by verifying that the System LED is illuminated.
2 Press and hold the Reset button for 30 seconds. The button can be found on the back of the
router, to the left of port 1.
3 After 10 seconds, the Diag LED will begin flashing slowly. After 30 seconds the Diag LED
will begin flashing quickly. Release the Reset button once the Diag LED is flashing quickly.
The Diag LED will continue flashing and turn solid when the reset is complete.
4 The router is now reset to Cisco factory defaults.
Cisco Factory Default Settings
Parameter Default Value
Username: admin
Password: admin
LAN IP: 192.168.1.1
DHCP Range: 192.168.1.100 to 149
Netmask 255.255.255.0
Figure D-1: Cisco Factory Default Setting Screen

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GILBARCO VEEDER-ROOT Applause Media System and is the answer not in the manual?

GILBARCO VEEDER-ROOT Applause Media System Specifications

General IconGeneral
BrandGILBARCO VEEDER-ROOT
ModelApplause Media System
CategoryServer
LanguageEnglish