EasyManuals Logo

GILBARCO VEEDER-ROOT Applause Media System User Manual

Default Icon
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017 Page C-7
Configuring Network for Gilbarco Dispenser IP Addresses
Configuring Site Server IP Addresses for Applause
Media System (when IP Addresses Are Changed)
Reset to Default IPs
From the Network Config menu, press 1 > Enter. This option resets all the IP addresses to the
default value. Following warning message appears before resetting the values to factory
defaults.
Figure C-7: Reset to Default IPs
Reset to Default IPs
Warning: This action will reset all IP address to
Gilbarco Factory Defaults.
Enter = Continue
Cancel = Exit
Set IP Addresses
From the Networking Configuration menu, press 2 > Enter. The Set IP Addresses screen
appears.
Figure C-8: Set IP Addresses
Set IP Addresses
1. Set CRIND Side A IP
2. Set CRIND Side B IP
4. Set SMART Merch Server IP
5. Set Netmask Address
6. Set Gateway Address
Cancel = Exit
Note: If SMART Connect
option is removed, then Set SMART Connect server IP does not
appear.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GILBARCO VEEDER-ROOT Applause Media System and is the answer not in the manual?

GILBARCO VEEDER-ROOT Applause Media System Specifications

General IconGeneral
BrandGILBARCO VEEDER-ROOT
ModelApplause Media System
CategoryServer
LanguageEnglish