28
If your A/V receiver is equipped with a DTS decoder, your
DVD+VCR can output DTS digital sound, but you MUST enable this
feature in the menu system.
NOTE: Select “On” ONLY if you have connected a DTS-equipped
A/V receiver to the DIGITAL AUDIO OUT (optical or coaxial) on
the DVD+VCR back panel.
1Open “Initial Setup” menu
Press the SETUP button while the DVD is in Stop mode.
2 Select “DVD”
Use the
/
buttons to highlight “DVD”, then press ENTER to
select.
3 Select “Audio”
Use the
/
buttons to highlight “Audio”, then press ENTER
to select.
4 Set “DTS”
Use the
/
buttons to highlight “DTS” then press the
button
to select one of the following options:
• Off - To use your DVD+VCR with an A/V receiver NOT equipped
with a DTS decoder.
• On – To use your DVD+VCR with an A/V receiver equipped with
a DTS decoder.
DTS
To Next Page
Loading...
