Gorgy Timing LEDI NETWORK iTS - An Output Is Not Visible in the Configuration WEB Page; The Screen Displays No Time Code! or NO TIME CODE

111
MDE-LEDInetworkITS-server-4078V1.3
 YES
WEB page is reachable, but the browser is unable to load it. Open a TELNET ses-
sion:
Telnet < ip address> 10000
Password : gtmt
Proceed to a , then . Refresh the WEB page.
AN OUTPUT IS NOT VISIBLE IN THE CONFIGURATION WEB PAGE ?
► Press ‘F5’ to refresh the WEB page, and go back to output panel. If the output is still
missing, see next point.
► Open a TELNET session:
Telnet < ip address> 10000
Password : gtmt
Proceed to a , then . Refresh the WEB page.
► If the output is still missing, open the device. Check the black cables connections
and the switches congurations (see Appendix D – MAINTENANCE / Output card
switches verication).

► “NO TIME CODE!” : verify your time source because the device is not synchronized.
► with the date : if your device receives time code, verify in the input
panel of the conguration WEB page that  is not checked.
ENGLISH