Gorgy Timing LEDI NETWORK iTS - Change the Settings; NTP Server Output Card Configuration

84
MDE-LEDInetworkITS-server-4078V1.3
3. FRONT DISPLAY INTERFACE

Open the WEB site of the LEDI Network ITS/DCLS/NTP Server (see part 5). Click on
the Output button. The current conguration of your product appears at the screen .
In this screen you can tune each card independently (see page 31). When you have
changed the settings, click on the Submit button. The modication should appear
immediately at the outputs or on the display.

You can add a NTP server output card to your LEDI network ITS/DCLS. By this way,
you can synchronize your different local networks on several NTP servers, synchroni-
zing themselves on the same hardware reference.
The NTP server card has to be congured by the same way than the LEDI Network ITS/
DCLS. Its default network conguration is DHCP mode with identier SCnnnnnn with
nnnnnn, the serial number on 6 digits.
The default SNMP name of the NTP server (that can be seen from a SNMP browser or
from a WEB browser) is nnnnnn with nnnnnn, the serial number on 6 digits.
To change the network parameters of the NTP server card, use the  tool :
see page 14). Like the LEDI Network ITS/DCLS, the NTP server output card provides
a  for ne conguration (see page 23) and a SNMP MIB for supervision
through the network.