Gorgy Timing LEDI NETWORK iTS - State setup; NTP Setup

To Next Page

To Previous Page

MDE-LEDInetworkITS-server-4078V1.3

4. WEB INTERFACE

4.2.3. State setup

The standard state of the product is displayed :

► State : Current state of the product (Free running, tracking…)

► Synchronization : Current state of the synchronization

(Input 1 is waiting, Input 1 is synchronizing...)

4.2.4. NTP Setup

When you click the NTP button, the conguration of the NTP server software is dis-

played.

DESCRIPTION

Here is the short description of the different elds:

► 

the stratum value to be stored in the NTP messages sends to the NTP clients.

► Reference ID

A 4 letters identier that gives information about the time refe-

rence. This value is put in the appropriate eld in the NTP frame

► When not synchronized

Dene the effect on some NTP elds when the device is not synchronized

. The

possible values are  ,  ,

, 

The LEDI Network ITS can be synchronized on up to three NTP servers. In fact, the

NTP software uses only one server at the same time but can commute to another ser-

ver when there is no or not enough reply.

The NTP conguration panel shows what is the synchronization mode used by the

server or selected by the NTP software. It also shows the servers dened by the user

or detected by the software

7/ Time code is not present (server is autonomous) or the received time-code indicates that external synchronization

is lost