75
MDE-LEDInetworkITS-server-4078V1.3
The real drift and offset of the LEDI Network ITS/NTP Server clock related to the NTP
server are estimated from a measured offset. This offset is computed by subtracting the
client clock date from the server clock date.
Periodically, the client estimate current offset from the server. This measure is done
using a message-passing mechanism as shown on following gure:
On a LAN, it takes some milliseconds between the time when the client asks for the
date and the time when it receives the reply. This time is due to transmission delay
on the network. It can vary because of network load or NTP server load. Worse, the
transmission time from client to server is generally not the same that the one from the
server to client.
Actually, on a large period of time, the difference of sum of client-server and server-
client transmission delays is zero. The NTP client algorithm implemented in the LEDI
Network ITS/NTP Server is designed to compensate transmission delay and to average
the measures.
The NTP client software has the ability to work with several NTP servers (up to 3 ser-
vers). When not enough reply is received from a server or this server doesn’t reply or
reply too slowly, the NTP client software uses an other one.
1. INTRODUCTION
Query server date
Receive reply date
ides side
Network
Return current server date
ENGLISH
To Next Page
Loading...