96
MDE-LEDInetworkITS-server-4078V1.3
4. WEB INTERFACE
►
The transmission delay compensation can be used to compensate the IRIG-B cable
length or GPS repeater loss for example.
Set the value in microsecond if you know the delay. In automatic mode, the trans-
mission delay of an input is calculated with its constant phase from the driving input.
If the driving input is in automatic, its compensation delay will be null, as it is the
reference for the device.
► Autonomy
If the time source is lost, the device can work in autonomous mode. When the auto-
nomy time end is reached, the device stops to provide time on his outputs or NTP
time. You can choose the autonomous duration or set it to innite duration.
►
Give the maximum phase difference (in seconds) allowed on the time source before
locking the NTP server software. This eld is initialized to “inactivated”.
To Next Page
Loading...