GOWEIL MS 100 - Adjusting Grinding Angle and Rotation Limiter

10.03.2009
6.6
Adjusting the grinding angle
Pos: 7.18 /KN2006-SM /Bedienung/0 07 1.1 Stillsetze n im Notfall --> A nlage und grösser e Maschine @ 9\mod_11444 32835796_1.doc @ 86788
As it is different for the different types of
The following steps are necessary:
.
device and rests safely against the end stop bolts.
1.
Loosen the clamping lever on one side.
2.
Hold the electric motor with one hand while loosening the second clamping lever.
3.
Adjust the grinding angle before retightening both clamping levers.
6.7
Adjusting the rotation limiter
Pos: 7.18 /KN2006-SM /Bedienung/0 07 1.1 Stillsetze n im Notfall --> A nlage und grösser e Maschine @ 9\mod_11444 32835796_1.doc @ 86788
The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside
the cutting surface and does not grind over the edge at the beginning or the end of the
The adjustment can be made for each
1.
Undo the
2.
Make the adjustment.
3.
Retighten the star screw.
6.8 Operation
Personal protective
equipment
Always wear the following protective equipment when operating the machine:

Protective clothing

Safety shoes

Safety goggles

Hearing protection
Knife sharpener
Adjusting the grinding angle
As it is different for the different types of
knive
s, the grinding angle must be adjustable.
The following steps are necessary:
Also make sure that the curved
knife
is securely clamped into the horizontal clamping
device and rests safely against the end stop bolts.
Loosen the clamping lever on one side.
Hold the electric motor with one hand while loosening the second clamping lever.
ATTENTION!
When opening
the second clamping lever, hold the electric motor only at
the front, as there is a RISK OF INJURY at the rear!!
Adjust the grinding angle before retightening both clamping levers.
TIP!
Setting the right grinding angle is easier for new knive
s.
Adjusting the rotation limiter
The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside
the cutting surface and does not grind over the edge at the beginning or the end of the
The adjustment can be made for each
knife.
Undo the
star screw.
Make the adjustment.
Retighten the star screw.
Always wear the following protective equipment when operating the machine:
Protective clothing
Safety shoes
Safety goggles
Hearing protection
Knife sharpener
MS 100
Operation
21
s, the grinding angle must be adjustable.
is securely clamped into the horizontal clamping
Hold the electric motor with one hand while loosening the second clamping lever.
the second clamping lever, hold the electric motor only at
the front, as there is a RISK OF INJURY at the rear!!
Adjust the grinding angle before retightening both clamping levers.
s.
The rotation limiter (end stop) must be set in such a way that the cup grinding wheel remains inside
the cutting surface and does not grind over the edge at the beginning or the end of the
knife.
Always wear the following protective equipment when operating the machine: