GOWEIL MS 100 - Switching the Machine Off

10.03.2009
6.9
Switching the machine off
1.
Switch the machine off using the
OFF switch (red button "0").
6.10
Linear grinding unit (additional equipment)
The linear grinding unit can be used to sharpen straight
Sharpening straight
knife
and mount it on the angle table of the linear grinding unit.
6.10.1
Attaching the linear grinding unit
See drawing "Attaching linear grinding unit"
Tightening torque for M6 => 10Nm
Tightening torque for M8 => 25Nm
6.10.2
Adjusting the linear grinding unit
Make the adjustments as described
rotation limiter"
.
.
Also make sure that the curved
and rests safely against the end stop bolts.
1.
Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses
each.
The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are
positioned in 15 degree increments.
Undo
quick
Knife sharpener
Switching the machine off
Switch the machine off using the
OFF switch (red button "0").
2.
Press the lockable cover of
the emergency stop switch
closed until it
place.
3.
Pull the power plug.
Linear grinding unit (additional equipment)
The linear grinding unit can be used to sharpen straight
knives.
knife
s merely requires that you remove
the adjusting plate from the grinding table
and mount it on the angle table of the linear grinding unit.
Attaching the linear grinding unit
See drawing "Attaching linear grinding unit"
Tightening torque for M6 => 10Nm
.
Tightening torque for M8 => 25Nm
.
Adjusting the linear grinding unit
Make the adjustments as described
on pages 19, item 6.
3 "Preparations" to 21
.
IMPORTANT!
When sharpening straight knive
s, make sure the surface to be ground is
horizontal. This means that the cup grinding wheel must be aligned horizontally
as well!
Also make sure that the curved
knife
is securely clamped into the horizontal clamping device
and rests safely against the end stop bolts.
Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses
The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are
positioned in 15 degree increments.
quick
-action locking screws – adjust angle – tighten quick-
action locking screw.
Knife sharpener
MS 100
Operation
23
Press the lockable cover of
the emergency stop switch
closed until it
locks into
place.
Pull the power plug.
the adjusting plate from the grinding table
3 "Preparations" to 21
, item 6.7 "Adjusting the
s, make sure the surface to be ground is
horizontal. This means that the cup grinding wheel must be aligned horizontally
is securely clamped into the horizontal clamping device
Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses
The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are
action locking screw.