Also make sure that the curved
rests safely against the end stop bolts.
Unscrew the cup grinding wheel on the bottom using a suitable tool and hold it with one hand.
Also make sure that the curved
rests safely against the end stop bolts.
Pull the cup grinding wheel including the spring washer off the motor axle.
Slip the new cup grinding wheel including the spring washer onto the motor axle and tighten it.
Tightening torque for M8 => 25Nm
8 Maintenance
Pos: 9.3 /KN2006- SM/Wartung/00 2 1 Sicherheit_Titel @ 9\mod_114 4434831619_1. doc @ 86810
8.1 Safety
Pos: 9.4 /KN2006-SM/Wartung/003 1.1.0 Personal --> Standard --
Unless specified otherwise, the maintenance steps des
Some maintenance steps may only be performed by specially trained qualified personnel or the
manufacturer. These steps will be pointed out separately in the description of the individual maintenance
All work on the electrical system must be performed by trained electricians.
Personal
protective
equipment
Wear the following protective equipment when performing maintenance:
Safety shoes
Safeguard
against restart
Risk of fatal injury caused by unauthorized restart!
Performing maintenance work always involves the risk of the power supply being switched
on without authority. This may cause fatal injuries to any person
Also make sure that the curved
is securely clamped into the horizontal clamping device and
rests safely against the end stop bolts.
Unscrew the cup grinding wheel on the bottom using a suitable tool and hold it with one hand.
Also make sure that the curved
is securely clamped into the horizontal clamping device and
rests safely against the end stop bolts.
Pull the cup grinding wheel including the spring washer off the motor axle.
Mark the cup grinding wheel as used and dispose of it!
Slip the new cup grinding wheel including the spring washer onto the motor axle and tighten it.
Tightening torque for M8 => 25Nm
The new cup grinding wheel must not be exposed to blows!
RISK of bursting during operation!
\mod_1144434832402_1.doc @ 86817
Unless specified otherwise, the maintenance steps des
cribed herein can be performed by the operator.
Some maintenance steps may only be performed by specially trained qualified personnel or the
manufacturer. These steps will be pointed out separately in the description of the individual maintenance
All work on the electrical system must be performed by trained electricians.
Wear the following protective equipment when performing maintenance:
Risk of fatal injury caused by unauthorized restart!
Performing maintenance work always involves the risk of the power supply being switched
on without authority. This may cause fatal injuries to any person
inside the hazard area of
Switch off all power supplies and secure them against restart before commencing any
is securely clamped into the horizontal clamping device and
Unscrew the cup grinding wheel on the bottom using a suitable tool and hold it with one hand.
is securely clamped into the horizontal clamping device and
Slip the new cup grinding wheel including the spring washer onto the motor axle and tighten it.
The new cup grinding wheel must not be exposed to blows!
cribed herein can be performed by the operator.
Some maintenance steps may only be performed by specially trained qualified personnel or the
manufacturer. These steps will be pointed out separately in the description of the individual maintenance
Performing maintenance work always involves the risk of the power supply being switched
inside the hazard area of
Switch off all power supplies and secure them against restart before commencing any
To Next Page
Loading...