GOWEIL MS 100 - Positioning Knives for Krone VP 1500 and VP 1800 Round Bale Presses

Knife sharpener MS 100
Operation
24
.
Also make sure that the curved
and rests safely against the end stop bolts.
2.
Level the cup grinding wheel an
21
, item 6.6 „Adjusting the grinding angle“)
3.
The work flow is the same as described
NOTICE!
If not needed, the linear grinding unit can be folded
TIP!
Setting the right grinding angle is easier for new
6.11 Positioning knive
s for Krone VP 1500 and VP 1800 round bale presses
Shown below are special setting specifications for
presses!
IMPORTANT!
The specifications below are guide values as they may vary slightly depending on
the wear on the
6.11.1 Setting the adjusting plate/
knife
The
specified dimension is merely intended as a guide value!
6.11.2 Adjusting the grinding unit
6.11.2.1 Retaining plate –
adjusting distance, grinding angle
IMPORTANT!
You must turn the rotary unit
“Adjusting the grinding unit“
The specified dimensions are merely intended as guide values!
275mm
270 mm
Also make sure that the curved
knife
is securely clamped into the horizontal clamping device
and rests safely against the end stop bolts.
Level the cup grinding wheel an
d the cutting surface into a horizontal position (0 degrees) (
, item 6.6 „Adjusting the grinding angle“)
The work flow is the same as described
on page 22, item 6.8.1 "Work flow".
NOTICE!
If not needed, the linear grinding unit can be folded
away.
Setting the right grinding angle is easier for new
knives.
s for Krone VP 1500 and VP 1800 round bale presses
Shown below are special setting specifications for
knives used in
Krone VP 1500 and VP 1800 round bale
IMPORTANT!
The specifications below are guide values as they may vary slightly depending on
the wear on the
knives!
knife
position on the adjusting plate
specified dimension is merely intended as a guide value!
Correct position of the knife!
adjusting distance, grinding angle
IMPORTANT!
You must turn the rotary unit
of the grinding unit by 180°! See page
20
“Adjusting the grinding unit“
The specified dimensions are merely intended as guide values!
40mm
10.03.2009
is securely clamped into the horizontal clamping device
d the cutting surface into a horizontal position (0 degrees) (
page
s for Krone VP 1500 and VP 1800 round bale presses
Krone VP 1500 and VP 1800 round bale
The specifications below are guide values as they may vary slightly depending on
20
, item 6.5