74
Reinstalling the Hook Holder (Continued)
Repairs and Diagnostics
3. Remove the bobbin case (see “Loading the
Bobbin Case” on page 29).
3
4. Remove the needle plate using the at-head
screwdriver (see “Reinstalling the Needle
Plate” on page 62).
4
Installation Instructions
1. Turn o the machine.
2. Rotate the hand wheel to raise the needle
to the highest point.
2
1
5. Turn the inside portion of the hook
assembly (shown in blue) so that the
positioning guide is at the highest point.
5
Positioning Guide
6. Slide the nger of the hook holder
(shown in gray) into the middle of the hook
assembly’s positioning guide.
6
1. Attach loosely with the hook holder screw.
Do not tighten.
7
Hook Holder
Screw
Hand Wheel
To Next Page
Loading...
