Technical Specifications
50 3A8572B
Technical Specifications
Fluid Temperature Range
NOTE: The maximum fluid temperature for Hazardous units should not exceed 230°F (110°C) or the limitation
based on the Wetted Section Materials, whichever is lower.
NOTICE
Temperature limits are based on mechanical stress only. Certain chemicals will further limit the fluid temperature
range. Stay within the temperature range of the most-restricted wetted component. Operating at a fluid
temperature that is too high or too low for the components of your pump may cause equipment damage.
Material of Wetted
Contact Section Parts
(Seat, Check,
Diaphragm)*
Fluid Temperature Range by Wetted Section Material
Metal (AL,CI, CP, FG, HS, HT,
PH, SS, 3A)*
Plastic (PV)* Plastic (AC, CP, PP)*
Fahrenheit Celsius Fahrenheit Celsius Fahrenheit Celsius
AC –20° to 180° –29° to 82°
10° to 180° –12° to 82°
32° to 150° 0° to 66°
AL –60° to 275° –51° to 135°
BN 10° to 180° –12° to 82°
CO 10° to 180° –12° to 82°
CR 10° to 180° –12° to 82°
CW 10° to 180° –12° to 82°
EO –40° to 250° –40° to 121°
EP –60° to 275° –51° to 135°
FK –40° to 275° –40° to 135°
FL –60° to 275° –51° to 135°
GE –40° to 180° –40° to 82°
HD –60° to 275° –51° to 135°
PO –40° to 180° –40° to 82°
PP 32° to 175° 0° to 79° 32° to 175° 0° to 79°
PS –40° to 180° –40° to 82°
10° to 180° –12° to 82°
PT –40° to 220° –40° to 104°
PU –40° to 200° –40° to 93°
PV 10° to 225° –12° to 107°
SA –40° to 220° –40° to 104°
SB –40° to 275° –40° to 135°
SC –40° to 180° –40° to 82°
SD –40° to 220° –40° to 104°
SO –40° to 180° –40° to 82°
SP –40° to 180° –40° to 82°
SS –60° to 275° –51° to 135°
TP –20° to 150° –29° to 66°
UD –60° to 200° –51° to 93°
* See Configuration Matrix, starting on page 7, for detailed descriptions.
To Next Page
Loading...
