d. Prefer Primary SIP Server to No or Yes depending on your configuration. Set to No if no
failover SIP server is defined. If “Yes”, account will register to primary SIP server when
failover registration expires.
e. Outbound Proxy with your outbound proxy IP address or FQDN. Leave empty if not
available.
6. Press Save and Apply to save your configuration.
7. Go to DECT SIP Account Settings
Figure 16: SIP Settings
8. Configure your SIP details in desired account:
a. Account: Select Account row to configure (Account 1 – Account 10).
b. SIP User ID: User account information, provided by VoIP service provider (ITSP). Usually in
the form of digit similar to phone number or actually a phone number.
c. Authenticate ID: SIP service subscriber’s authenticate ID used for authentication. Can be
identical to or different from SIP User ID.
d. Password: SIP service subscriber’s account password to register to SIP server of ITSP. For
security reasons, the password will field will be shown as empty.
e. Name: Any name to identify this specific user.
f. Profile: Select the corresponding Profile ID (1/2/3/4).
g. HS Mode: Assign the account to specific handset (HS1, HS2…) or hunting group mode.
h. Active: Set to Yes. If set to No, account is disabled and will not register.
9. Press Save and Apply to save your configuration.
To Next Page
Loading...
Need help?
General
