Grandstream Networks GWN7600 - USING GWN76 XX AS STANDALONE ACCESS POINT; Connect to Default Wi-Fi Network

P a g e | 40
GWN7610/GWN7600/GWN7600LR User Manual
Version 1.0.8.18
USING GWN76XX AS STANDALONE ACCESS POINT
The GWN7610/GWN7600/GWN7600LR can be used in Standalone mode, where it can act as Master
Access Point Controller or in Slave mode and managed by another GWN76xx Master.
This section will describe how to use and configure the GWN7610/GWN7600/GWN7600LR in standalone
mode.
Connect to GWN76xx Default Wi-Fi Network
GWN7610/GWN7600/GWN7600LR can be used as standalone access point out of box, or after factory
reset with Wi-Fi enabled by default.
After powering the GWN7610/GWN7600/GWN7600LR and connecting it to the network,
GWN7610/GWN7600/GWN7600LR will broadcast a default SSID based on its MAC address GWN
[MAC’s last 6 digits] and a random password.
Note that GWN7610/GWN7600/GWN7600LR’s default SSID and password information are printed on the
MAC tag of the unit as shown on the below figure.
Figure 23: MAC Tag Label