Power and Connect GWN7610 Access Point
Step 1:
Connect one end of a RJ-45 Ethernet cable into the NET or PoE/NET port of the GWN7610.
Step 2:
Connect the other end of the Ethernet cable(s) into a LAN port to your Network.
Step 3:
Connect the 24V DC power adapter into the power jack on the back of the GWN7610. Insert the main plug
of the power adapter into a surge-protected power outlet.
Notes:
• GWN7610 can be powered using PoE(802.3af)/PoE+(802.3at) switch via PoE/NET port. In this
scenario, GWN7610 should be connected to the Router using NET port.
• GWN7610 has a PoE detection daemon that will monitor the status and update maximum
allowable power for USB ports in real time.
Step 4:
Wait for the GWN7610 to boot up and acquire an IP address from the DHCP Server.
Figure 2: Connecting GWN7610
Warranty
If the GWN7610 Wireless Access Point was purchased from a reseller, please contact the company where
the device was purchased for replacement, repair or refund. If the device was purchased directly from
Grandstream, contact our Technical Support Team for a RMA (Return Materials Authorization) number
before the product is returned. Grandstream reserves the right to remedy warranty policy without prior
notification.
To Next Page
Loading...
Need help?
General
