USING GWN7610 AS MASTER ACCESS POINT CONTROLLER
Master Mode allows a GWN7610 to act as an Access Point Controller managing other GWN7610 access
points. This will allow users adding other access points under one controller and managing them in an easy
and a centralized way.
Master/Slave mode is helpful with large installations that need more coverage area zones with the same
controller.
Figure 19: Login Page
At factory reset, “Set unit as Master” will be checked by default, click on “Sign In” after typing the admin’s
username and password.
Warning:
“Set unit as Master” option will forbid the GWN7610 Access Point from being paired by other Master
GWN7610, and can only act as a Master Access point controller.
Users will need to perform a factory reset to the GWN7610, or unpair it from the initial GWN7610 to make
it open to Master Access Point mode again.
Login Page
After login, users can use the Setup Wizard tool to go through the configuration setup, or exit and configure
it manually. Setup Wizard can be accessed anytime by clicking on while on the Web interface.
To Next Page
Loading...
Need help?
General
