GWN7610 User Manual
Version 1.0.5.15
The following table summarizes description for voucher configuration parameters:
Table 10: Voucher Parameters
Specify how many vouchers to generate which will have same
profile/settings (duration, bandwidth and number of users).
Specify how many users can use the voucher.
Specify the duration after which the voucher will expire, and clients
will be disconnected from internet.
Note: in case or multiple users, the duration will start counting after
first user starts using the voucher.
Set the downstream bandwidth speed limit (in Kbps or Mbps).
Set the upstream bandwidth speed limit (in Kbps or Mbps).
Notes for the admin when checking the list of vouchers.
Using Voucher with GWN captive portal
In order to successfully use the voucher feature, users will need to create a captive portal in order to request
voucher authentication codes from users before allowing them access to internet. More details about
captive portal will be covered on next section but for voucher configuration please follow below steps.
1. Go under “Captive Portal Captive portal” menu.
2. Press in order to add new captive portal policy.
3. Set the following parameters as shown on the screenshot for basic setup then save and apply.
Figure 44: Captive Portal with Voucher authentication
Then go under your network group configuration page and enable the generated captive portal under WiFi
settings tab.
To Next Page
Loading...
Need help?
General
