1. Connect to the GWN7610 Web GUI as Master and go to Access Points.
Figure 21:Discover AP
2. Click on to list discovered access points, the following page will appear.
Figure 22: Discovered Devices
Note: Discovered Slave Aps with lower firmware than the master AP will be highlighted in red bold to remind
the users to upgrade their AP, more details refer to [Controller Protocol Security Enhancement]
3. Click on Pair under Actions, to pair the discovered Access Point as Slave with the GWN7610 acting
as Master
4. The paired GWN7610 will appear Online, users can click on to unpair it.
Figure 23: GWN7610 online
To Next Page
Loading...
Need help?
General
