Note: Once you choose sequential upgrade, the number with beside the green upgrading icon will tell you
how many slaves have done its upgrading.
The status of the device will show Upgrading, wait until it finishes and reboots, then it will appear online
again.
Figure 58: GWN7610 Upgrading
----------------------------------------------------------------------------------------------------------------------------- ---------------
Notes:
• Please do not interrupt or power cycle the GWN7610 during upgrading process.
• The Master Access Point needs to be upgraded from Web GUISystem SettingsMaintenance.
It cannot be upgraded from Access Points page like the Paired Access Points.
--------------------------------------------------------------------------------------------------------------------------------------------
Service providers should maintain their own firmware upgrade servers. For users who do not have
TFTP/HTTP/HTTPS server, some free windows version TFTP servers are available for download from
http://www.solarwinds.com/products/freetools/free_tftp_server.aspx
http://tftpd32.jounin.net
Please check our Website at http://www.grandstream.com/support/firmware for latest firmware.
Instructions for local firmware upgrade via TFTP:
1. Unzip the firmware files and put all of them in the root directory of the TFTP server;
2. Connect the PC running the TFTP server and the GWN7610 to the same LAN segment;
3. Launch the TFTP server and go to the File menuConfigureSecurity to change the TFTP server's
default setting from "Receive Only" to "Transmit Only" for the firmware upgrade;
4. Start the TFTP server and configure the TFTP server in the GWN7610 Web configuration interface;
5. Configure the Firmware Server to the IP address of the PC;
6. Update the changes and reboot the GWN7610.
End users can also choose to download a free HTTP server from http://httpd.apache.org/ or use
Microsoft IIS Web server.
To Next Page
Loading...
Need help?
General
