Grandstream Networks WP826 - Key Description

Handset Menu
Keypad
Keypad Modes
The WP8x6 keypad can be used by tapping on an input field. The keypad has 4 modes “Ab2”, “ABC”, “abc” and “123”. The
default mode is “Ab2”.
“Ab2” Mode:
This mode allows you to enter capital letters, small letters, digits, and symbolic characters.
The following table describes the allowed characters for each key.
Key Description Key Description Key Description
1 . , ’ ? ! ” – 1 2
A B C a b c 2
3 D E F d e f 3
4 G H I g h i 4 5
J K L j k l 5
6 M N O m n o 6
7 P Q R S p q r s 7 8
T U V t u v 8
9 W X Y Z w x y z 9
* . , ‘ ? ! “ – ( ) @ / : _ ; + % * = < > $ [ ] { } ~ ^ # | ` & 0 Space # Switch mode
“Ab3” Mode
● Basic Settings: Configure the basic settings including voice settings, display settings, Gestures and button
customization, language settings and date/time settings.
● Adv. Settings: Configure the advanced settings including system upgrade, PTT/Paging settings, Alarm setting, system
security settings, syslog settings and factory reset / reboot.
● Zero Config: This setting configurs the parameters used when adding the WP phone with GCC Fast provisioning
service.
● Wi-Fi Settings: Enables/Disables Wi-Fi service, it can also Configure the Wi-Fi connection parameters, such as the
Wi-Fi band, Alarm Threshold...
● Quick Network Configuration: Quickly set up your phone's Wi-Fi using two methods: access via mobile browser or
adjust settings directly on the device for a local solution.
● Bluetooth Settings: Configures the bluetooth pairing settings.
● Diagnostics: Displays a set of different device and system diagnostic tools, including the LCD, LED diagnostic tests,
ping and traceroute tests, as well as Sensor Data tests.
Status
● Account status: Displays account status whether it is registered or not.
● Warnings: Displays the current alert messages for the phone, this can be messages about failed configuration
downloads, Low Battery warning...
● Network status: Press to enter the sub menu for MAC address, IP setting information (DHCP/Static IP), IPv4 address,
IPv6 address, Subnet Mask, Gateway, DNS server, network statistics...
● System Status: Press to enter the sub menu for Running memory, Storage status, MAC address, System version,
Recovery version, U-boot version, Kernel version, Hardware version, PN number, Country code and Running time.
● CPE status: CPE status includes signal strength and network connection stability indicators, such as CPE link, CPE
STUN etc., it also contains a tool to run a global CPE diagnosis
● Battery Status: includes information such as the remaining battery percentage and charging status indicator...