Configuring Ambient Sound Alarm
No Movement Alarm
No Movement Alarm allows to monitor the user’s motion. If no movement is detected within a configured time frame, the
handset will send an alert.
To configure the alarm, users must select a detection sensitivity level from 1 to 7, where Level 1 is the lowest and Level 7 is
the highest. Additionally, users should set a No Movement Timeout in seconds, which defines the duration without
movement before the warning is triggered.
Please refer to the following steps to configure this alarm:
1. Quickly press the side key to access the alarm settings (if the side key is configured as “alarm”), or go to
Settings→Advanced Settings→Alarm Settings.
2. Select Alarm Monitoring and set the No Movement Alarm level.
3. Configure the No Movement Timeout, the allowed range is 5 to 300 seconds.
4. Click on the left Softkey (OK) to confirm the changes.
5. The warning will be triggered as soon as no movement is detected for the specified duration. (as shown in the figure)
To Next Page
Loading...
