Ending Calls
To terminate the calls, press the Hang-Up key .
Rejecting Calls
To reject an incoming call, press the Hang-Up key .
Call Hold/Resume
During an active call, press the right softkey “Hold” to put the established call on hold.
To resume the call, press the right softkey “Resume” while the established call is being on hold.
Hold/Unhold Calls
Call Waiting
This feature will notify you of a new incoming call during an established call and display the incoming call information visually
on the LCD screen and a call waiting tone will be heard. If this feature is disabled, the new incoming call will be automatically
rejected.
This feature is enabled from the Web GUI:
1. Access Web Interface.
2. Go to Accounts
🡪
Call Settings
3. Set “Enable Call Waiting ” to “Yes”.
4. Press the Save and Apply buttons to confirm the new settings.
Users now will be able to hear the call waiting tone and it will be visible as well on the LCD screen as displayed in the
following screenshot.
Note
If you press on “Options” during the established call, and then make a new call to another number, the first call will be on hold
automatically and users can put up to 2 calls on hold at the same time.
To Next Page
Loading...
