Configuring No Movement Alarm
Man Down Alarm
The Man Down Alarm is triggered when the user has fallen or is unresponsive, in order to ensure that prompt action is taken
in emergency situations.
To configure the alarm, users must set a detection sensitivity level from 1 to 7, where Level 1 is the lowest and Level 7 is the
highest. Additionally, users should set the Man Down Timeout (in seconds), which defines the duration the user remains in
the man down position before the warning is triggered.
In order to configure the Man Down Alarm, please follow the instructions below:
1. Quickly press the side key to access the alarm settings (if the side key is configured as “alarm”), or go to
Settings→Advanced Settings→Alarm Settings.
2. Select Alarm Monitoring and set the Man Down Alarm level.
3. Configure the Man Down Timeout. (Valid range is 5 to 300 seconds)
4. Click on the left Softkey (OK) to confirm the changes.
5. The warning will be triggered if the man down position is maintained for the specified duration. (as show in the figure)
To Next Page
Loading...
