Enabling both AI Noise Reduction and Noise Shield
Ringtones
Setting the Ringer Volume
To configure the desired ringer volume, proceed as follows:
1. Press Menu to bring up the operation menu and go to Settings.
2. Navigate to Basic Settings, and then select the Sounds tab.
3. Users can configure the silent and vibrate modes and also the voice ringtones by pressing the left and right arrow keys to
change repeatedly and set the desired volume.
4. Press “On-Hook” to confirm the new configuration settings.
Notes:
10 levels are supported. Level 10 is the highest. Level 5 is the default.
appears when silent mode is enabled. In this mode, no ring will be played for incoming calls.
Ringer Volume
Setting the Ringtones
You can change the ringer melody for an incoming call. The device has different ringer melodies and to configure the desired
melody, proceed as follows:
1. Press Menu to bring up the operation menu.
2. Use the arrow keys to reach Settings 🡪 Basic Settings, and then select the Sounds tab.
3. Go to “Incoming ringtone”, and choose the account that the ringtone will be applied on, then select the desired
ringtone, and press “Save” to confirm the ringtones selected and the new ringtones will be set successfully.
Calls Default Ringtone
Date and Time
On the WP8x6 the Date and time are displayed on the idle screen and it obtains the date and time from the Simple Network
Time Protocol (SNTP) server by default. If your phone cannot obtain the date and time from the SNTP server, you need to
configure the date and time manually. You can configure the time format and date format respectively. The handset supports
To Next Page
Loading...
