Options: FC5100 Auto Registration Mark Sensor
180
• Press the F1 key to select AUTO REG. MARK.
• Press the F2 key to select MARK TYPE.
• Press the F3 key for pattern type 1 or the F4 key to select pattern type 2 to be
used when printing the image and registration mark on the media. A mark
appears next to the current setting.
• Press the ENTER key to register your setting. The following menu appears. If
you wish to set another parameter, press the key corresponding to that setting.
• Press the MENU key to cancel menu mode when all of the parameters are set.
Specifying the
Registration
MARK SIZE
The MARK SIZE function allows you to specify the size of the registration mark.
The size of the registration mark is important. The line width must be between
0.3mm and 1.0mm and the length must be between 5mm and 20mm.
• Press the MENU key to select MENU mode.
• Press the NEXT key.
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
MARK TYPE*
*
1*
2 *
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
To Next Page
Loading...