Options: FC5100 Auto Registration Mark Sensor
189
If the two cross marks match, set 00.0 mm on both the X and Y-axis.
• Press the ENTER key to register your setting. The following menu appears.
If you wish to set another parameter, press the key corresponding to
that setting.
• Press the MENU key to cancel menu mode when all of the parameters are set.
SELECTING METHOD 2
The plotter plots the cross mark, reads it, and plots another cross symbol for use in
determining the corrective values to be input in order to adjust the precision of the
registration mark sensor. The plotter plots the second cross mark based on the
reading of the first cross mark then adjusts for offset.
• Press the POSITION key to move the pen to plot the first cross mark.
• Press the F4 key to select SCAN
The plotter plots the first cross mark. The following menu appears.
SENSOR OFFSET ADJUST
METHOD 1>.
METHOD 2>.
SENSOR OFFSET ADJUST
PARAMETER SET>.
SCAN>.
Current pen position
Second cross mark
plotted by the plotter
X
Y
-Y
-X
+Y
Axis direction
Media feed
direction
+X
First cross mark
printed by the plotter
To Next Page
Loading...